![]() Please consult your plasma cutter documentation for appropriate pierce delay settings for your cutter. The pierce delay is dependent on your plasma cutter and the thickness of material being cut. Pierce Delay (sec): The pierce delay value is the amount of time that the torch remains stationary after firing in order to fully pierce the material before moving down to the Cut Height.If you are using a CrossFire without a powered z-axis, set this value to No. IHS: Use this toggle to enable or disable Initial Height Sensing switch on your machine. ![]() If you are using a CrossFire without a powered Z-axis, set this value to 0. The IHS switch applies approximately 2lbs of force to your material when detecting the plate height and this springback value can compensate for the deflection.
0 Comments
Leave a Reply. |